[Free] 2018(Jan) EnsurePass Pass4sure Juniper JN0-343 Dumps with VCE and PDF 291-300

Ensurepass.com : Ensure you pass the IT Exams
2018 Jan Juniper Official New Released JN0-343
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/JN0-343.html

Juniper Networks Certified Internet Specialist (JNCIS-ENT)

Question No: 291 – (Topic 3)

Ensurepass 2018 PDF and VCE

Refer to the command-line output shown in the exhibit. How many routes has this router received from the BGP peer at 10.10.10.1?

  1. 0 routes

  2. 2 routes

  3. 3 routes

  4. 57 routes

Answer: C

Question No: 292 – (Topic 3)

Which type of port must be an 802.1Q tagged port?

  1. access

  2. LAG

  3. LACP

  4. trunk

Answer: D

Question No: 293 – (Topic 3)

Which two requirements are needed to load balance traffic per flow? (Choose two.)

  1. a destination with equal cost paths

  2. a properly applied policy with an action to load-balance per-packet

  3. a properly applied policy with an action to load-balance per-flow

  4. a destination with multiple active routes

Answer: A,B

Question No: 294 – (Topic 3)

Your customer wants to connect a VoIP phone to interface ge-0/0/5 on an EX4200 switch in VLAN 20 and connect a PC to the VoIP phone. The PC should be part of VLAN 30.

Which two commands will implement this solution? (Choose two.)

  1. set interface ge-0/0/5.0 family ethernet-switching vlan members vlan-30

  2. set ethernet-switching-options voip interface ge-0/0/5.0 vlan 20

  3. set interface ge-0/0/5.0 family ethernet-switching vlan members vlan-20

  4. set ethernet-switching-options voip interface ge-0/0/5.0 vlan 30

Answer: A,B

Question No: 295 – (Topic 3)

An IP-IP tunnel must meet which two requirements to function correctly? (Choose two.)

  1. The tunnel end points must have a valid route to each other.

  2. The tunnel end points must be distributed inside the IGP.

  3. A GRE tunnel must be established first to carry the IP-IP tunnel.

  4. All devices in between the tunnel end points must have a valid route to the tunnel end points.

Answer: A,D

Question No: 296 – (Topic 3)

A router is configured to use standard metrics. The router has a single link to a Level 2 IS- IS neighbor.

What is the maximum metric for that link?

A. 63 B. 254 C. 1023

D. 65534

Answer: A

Question No: 297 – (Topic 3)

ESTION NO: 249

You must create an IP-IP tunnel between two routers on your network. These two devices are separated by 10 hops. The tunnel appears to be established, but no traffic is traversing the tunnel. What causes this behavior?

  1. The tunnel#39;s TTL has not been modified from the default value of 8.

  2. Traffic is being dropped along the path because a configured MTU is greater than the tunnel#39;s MTU.

  3. A route that directs traffic into the tunnel is not present.

  4. BGP has not been enabled between tunnel end-points.

Answer: C

Question No: 298 – (Topic 3)

Which type of OSPF area restricts external routes from other areas but allows external routes to be flooded by ASBRs within its own area?

  1. not-so-stubby area

  2. backbone area

  3. stub area with no-summaries configured

  4. stub area

Answer: A

Question No: 299 – (Topic 3)

Which statement is true regarding the minimum-interval configuration shown below?

user@router# show ospf area 0.0.0.0 {

interface ge-0/0/1.0 { bfd-liveness-detection { minimum-interval 300;

}

}

}

  1. It is the minimum hold time before BFD informs OSPF that the BFD session has been torn down.

  2. It enables minimum transmit and receive intervals for 300 ms.

  3. It enables minimum transmit and receive intervals for 300 seconds.

  4. It is the minimum amount of time that the BFD session must remain alive before changing state.

Answer: B

Question No: 300 – (Topic 3)

A company#39;s Junos-based router has two EBGP peers and receives two BGP update messages with the following information:

Peer A – AS path [ 65001 64513 12 ] ; MED 67 ; origin value 1 Peer B – AS path [ 65002 64513 12 ] ; MED 70 ; origin value 2

Assuming default values, how will the company router react to these updates?

  1. The path through Peer A will be preferred for all traffic to that destination.

  2. The path through Peer B will be preferred for all traffic to that destination.

  3. The paths will be load balanced to that destination based on a Layer 3 hash.

  4. The company router marks the routes as hidden to that destination because the MED exceeds 63.

Answer: A

Topic 4, Volume D

100% Ensurepass Free Download!
Download Free Demo:JN0-343 Demo PDF
100% Ensurepass Free Guaranteed!
JN0-343 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.