[Free] 2018(Jan) EnsurePass Pass4sure Juniper JN0-360 Dumps with VCE and PDF 191-200

Ensurepass.com : Ensure you pass the IT Exams
2018 Jan Juniper Official New Released JN0-360
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/JN0-360.html

Juniper Networks Certified Internet Specialist, – Service Provider (JNCIS-SP)

Question No: 191

– Exhibit –

user@r1gt; show interfaces terse ge-1/0/0 Interface Admin Link Proto Local Remote ge-1/0/0 up up

ge-1/0/0.0 up up inet6 fe80::226:88ff:fe02:7481/64 fec0:0:0:2003::1/64

– Exhibit –

Click the Exhibit button.

You run the command show interfaces terse ge-1/0/0 and see the output shown in the exhibit.

Why are two addresses being shown for this interface?

  1. Two addresses are assigned in IPv6, one for the physical and one for the logical interface.

  2. Two addresses are seen because the loopback address of the router is associated with the interface.

  3. The two addresses being seen are the link-local and site-local.

  4. An IPv6 address conflict is being seen; verify your interface configuration for problems.

Answer: C

Question No: 192

Click the Exhibit button

Ensurepass 2018 PDF and VCE

Which two topologies shown in the exhibit would require the use of a spanning-tree protocol? (Choose two)

  1. ring

  2. tree

  3. star

  4. mesh

Answer: A,D

Question No: 193

Which IS-IS PDU is used to request a retransmission of a missing link-state packet?

  1. the complete sequence number PDU

  2. the partial sequence number PDU

  3. a hello PDU with a request PDU TLV specifying the missing LSP

  4. a hello PDU with a refresh PDU TLV requesting all LSPs

Answer: B

Question No: 194

On an MX Series device with dual Routing Engines, which two conditions cause a unified ISSU to fail? (Choose two.)

  1. Graceful restart is disabled.

  2. BFD is enabled.

  3. GRES is disabled.

  4. NSR is disabled.

Answer: C,D

Question No: 195

Click the Exhibit button.

Ensurepass 2018 PDF and VCE

In the exhibit Router A and Router B are operating on the LAN with Router B acting as the designated intermediate system (DIS).

When Router C and Router D are added to the LAN. Which statement is true?

  1. Router C becomes the new DIS with no backup DIS.

  2. Router D becomes the new DIS with no backup DIS.

  3. Router C becomes the new DIS with Router B as the backup DIS.

  4. Router D becomes the new DIS with Router A as the backup DIS.

Answer: A

Question No: 196

Which two statements are correct about neighbor discovery in IPv6? (Choose two.)

  1. Neighbor discovery relies on ARP to find neighbors on a local link.

  2. A neighbor is considered reachable when the neighboring device responds to a neighbor solicitation message.

  3. A neighbor is considered reachable when the neighboring device responds to a router solicitation message.

  4. Neighbor discovery does not use ARP to find neighbors on a local link.

Answer: B,D

Question No: 197

Click the Exhibit button.

Ensurepass 2018 PDF and VCE

Which two topologies shown in the exhibit could be implemented without a spanning-tree protocol? (Choose two.)

  1. ring

  2. tree

  3. star

  4. mesh

Answer: B,C

Question No: 198

– Exhibit – user@R2gt; show protocols {

isis {

export leak; interface ge-1/1/0.0; interface ge-1/1/1.0 { level 1 disable;

}

interface lo0.0;

}

}

policy-options {

policy-statement leak { term 1 {

from level 1;

to level 2; then accept;

}

}

}

– Exhibit –

Click the Exhibit button.

R1 and R2 have a Level 1 IS-IS adjacency. R2 participates in both Level 1 and Level 2, and is receiving routes from a Level 2 neighbor. A policy on R2 has been created to leak routes to Level 1, but R1 is not receiving the routes.

Referring to the exhibit, what is the solution on R2?

  1. The policy must be applied as an export policy at the interface level.

  2. The policy must be changed to include from protocol isis.

  3. The policy must be changed to specify from level 2 and to level 1.

  4. The policy must be applied as an import policy.

Answer: C

Question No: 199

Click the Exhibit button.

Ensurepass 2018 PDF and VCE

In the exhibit, R1 is sending the 172.16.100.0/24 route to R2 through EBGP. R2 has IBGP sessions to R3 and R4, but they are not installing the route. All BGP sessions are established.

Which two actions would enable R3 and R4 to install the route from R2? (Choose 2.)

  1. Advertise the R1-R2 link into the IGP.

  2. Configure the cluster-id parameter under the R2 IBGP group.

  3. Configure a BGP export policy with a next-hop self action on R2.

  4. Configure an IGP export policy with a next-hop self action on R2.

Answer: A,C

Question No: 200

Which statement is true about routing instances on Junos devices?

  1. Routing information cannot be shared between routing instances.

  2. Each routing protocol runs in a separate routing instance.

  3. Junos devices support only one routing instance.

  4. Each routing instance is a unique grouping of routing tables, interfaces, and routing protocol parameters.

Answer: D

100% Ensurepass Free Download!
Download Free Demo:JN0-360 Demo PDF
100% Ensurepass Free Guaranteed!
JN0-360 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.